Drilling and Well Operations
Asset and Integrity Management
Safety and Risk
Decarbonization and Energy Transition
Training and Advisory
Health, safety, environment and quality (HSEQ)
Management and The Board
28 Sep 2016
In regions such as Norway, where the governing regulatory agency only grants permit to drill wells that can be killed with a single relief well, the RWIS will provide a strategic solution that will enable drilling of both shallow and deep prolific reservoirs. In some cases, the RWIS may provide a tangible cost reduction in the range of 2 million USD by omitting a casing string to reduce dynamic kill requirements in the event of a blowout.
The RWIS is designed to be installed on a relief well prior to intersecting the blowout well and would be positioned between the wellhead and the blowout preventer (BOP), effectively becoming a subsea injection manifold providing additional inlets for pumping kill mud. Each of these inlets is equipped with dual fail-safe barrier valves to provide the necessary means of pressure containment in the relief well. During the well kill operation, one or more high-pressure pumping vessels located near the relief well rig will be connected to the RWIS inlets using high pressure flexible flowlines to provide the additional mud fluid. The RWIS can be rapidly deployed by air, ground and marine freight to any region of the world.
As a result of the projected solution provided to drilling operations, the RWIS has already been requested for specific wells in Norway and U.S.A, and will be available to the market by the end of 2016.